H. Karimi; A. Lakzian; Gh. haghnia; H. Emami; M. Soufi
Abstract
Introduction: Soil erosion by water is one of the most widespread forms of land degradation and it has caused many undesirable consequences in last decades. On steep slopes, rill erosion is the most important type of erosion, which produces sediment and rill flow. It can be also considered as a vehicle ...
Read More
Introduction: Soil erosion by water is one of the most widespread forms of land degradation and it has caused many undesirable consequences in last decades. On steep slopes, rill erosion is the most important type of erosion, which produces sediment and rill flow. It can be also considered as a vehicle for transporting soil particles detached from upland areas. Recent studies indicate that soil detachment rates are significantly influenced by land use. It is also known that there is a major difference between detachment rates of disturbed and natural soils (Zhang et al., 2003). Plowing rills especially in steep slopes increases sediment production. Sun et al. (2013) reported that the contribution of rill erosion in hill slope lands in china was more than 70%, which was approximately 50% of total soil erosion. In addition, measured soil loss is statistically related to hydraulic indicators such as slope, water depth, flow velocity, flow shear stress and stream power (Knapen et al., 2007). This study aims to evaluate the effects of hydraulic variables (shear stress and stream power) on spatial-temporal soil detachment rate. The focus is on the plowing rills in hillslope areas under wheat dry farming cultivation.
Materials and Methods: The study area is located in hilly slopes with the slope of 22.56% under dry farming wheat cultivation at 60 km of west of Shiraz, Iran. Top-down conventional plowing was carried out in order to create 10 meters furrows. Slope and cross sections of rills were measured throughout the experiment at 1 m intervals by rill-meter. Water was added to the top of the rills for 10 minutes and inflow rates were 10, 15 and 20 L min-1. Hydraulic parameters such as shear stress and stream power were calculated measuring rill morphology and water depth. Flow velocity and hydraulic radius along the different rill experiments were also calculated. Sediment concentrations were measured in three equal regular time and distance intervals (measurement points (MPs)), they were considered to calculate sediment detachment rate in different times and sections of each rill experiment for spatial and temporal soil detachment rate evaluation. One-way analysis of variance (ANOVA) was employed to test the significance of differences of sediment detachment rate among different treatments.
Results and Discussion: The results showed that the maximum values of shear stress and stream power were 14.07 Pa and 10.29 Wm-2 and the minimum values were 7.41 and 2.77 respectively. This research also indicated that changes in longitudinal profile of these hydraulic parameters along the rills affected the soil detachment rate values. Obtained average, minimum and maximum of the soil detachment rate were determined as 0.09, 0.02 and 0.22 kgm-2s-1, respectively. Due to Detachment-Transport Coupling mechanism, there was a significant difference between the initial and following MPs (P
