mostafa yaghoobzadeh; Saeid Boroomand Nasab; Zahra Izadpanah; Hesam Seyyed Kaboli
Abstract
Introduction: Accurate estimation of evapotranspiration plays an important role in quantification of water balance at awatershed, plain and regional scale. Moreover, it is important in terms ofmanaging water resources such as water allocation, irrigation management, and evaluating the effects of changing ...
Read More
Introduction: Accurate estimation of evapotranspiration plays an important role in quantification of water balance at awatershed, plain and regional scale. Moreover, it is important in terms ofmanaging water resources such as water allocation, irrigation management, and evaluating the effects of changing land use on water yields. Different methods are available for ET estimation including Bowen ratio energy balance systems, eddy correlation systems, weighing lysimeters.Water balance techniques offer powerful alternatives for measuring ET and other surface energy fluxes. In spite of the elegance, high accuracy and theoretical attractions of these techniques for measuring ET, their practical use over large areas might be limited. They can be very expensive for practical applications at regional scales under heterogeneous terrains composed of different agro-ecosystems. To overcome aforementioned limitations by use of satellite measurements are appropriate approach. The feasibility of using remotely sensed crop parameters in combination of agro-hydrological models has been investigated in recent studies. The aim of the present study was to determine evapotranspiration by two methods, remote sensing and soil, water, atmosphere, and plant (SWAP) model for wheat fields located in Neishabour plain. The output of SWAP has been validated by means of soil water content measurements. Furthermore, the actual evapotranspiration estimated by SWAP has been considered as the “reference” in the comparison between SEBAL energy balance models.
Materials and Methods: Surface Energy Balance Algorithm for Land (SEBAL) was used to estimate actual ET fluxes from Modis satellite images. SEBAL is a one-layer energy balance model that estimates latent heat flux and other energy balance components without information on soil, crop, and management practices. The near surface energy balance equation can be approximated as: Rn = G + H + λET
Where Rn: net radiation (Wm2); G: soil heat flux (Wm2); H: sensible heat flux (Wm2); and λET: latent heat flux (Wm2). Simulations were carried out by SWAP model for two different sites in Faroub and Soleimani fields. The SWAP is a physically based one-dimensional model which simulates vertical transport of water flow, solute transport, heat flow and crop growth at the field scale level. The period of simulation covered the whole wheat growing season (from 1st of December2008 to 30th of July2009. 16 MODIS images was used to determine evapotranspiration during wheat growing season. Inverse modeling of evapotranspiration (ET) fluxes was followed to calibrate the soil hydraulic. While SWAP model has the advantage of producing the right amount of irrigation and evapotranspiration at high temporal resolution, SEBAL can estimate crop variables like leaf area index, NDVI index, net radiation, Soil heat flux, Sensible heat flux and evapotranspiration athigh spatial resolution.
Results and Discussion: Actual and potential evapotranspiration were estimated for SWAP Model during the whole wheat growing season around669.5 and 1259.6 mm for Farub field and 583.7 and 1331.2 mm for Soleimani field, respectively. In contrast with NDVI and net radiation,spatial distribution of SEBAL parameters indicated that soil heat flux, sensible heat flux, and surface temperature of land have the same behavior. At the planting date, evapotranspiration was low and about 1 mm/day, but at the peak of plant growth, it was about 9 mm/day. Moreover, evapotranspiration declined at late growing season to about 3 mm/ day. SWAP model has been calibrated and validated with meteorological data and the data of field measurements of soil moisture. The amount of RMSE of 0.635 and 0.674 (mm/day) and MAE of 0.15 and 0.53 (mm/day) and also coefficient of determination (R2) of 0.915 and 0.964 obtained from comparison of SEBAL algorithm with SWAP model for Farub and Soleimani fields showed that no significant differences was seen between results of two models.
Conclusion: The present study supports the use of SEBAL as the most promising algorithm that requires minimum input data of ground based variables. Results of comparison of SEBAL and SWAP model showed that SEBAL can be a viable tool for generating evapotranspiration maps to assess and quantify spatiotemporal distribution of ET at large scales. Also, it feels that SEBAL and SWAP models can be applied in a wide variety of irrigation conditions without the need for extensive field surveys. This helps significantly in identifying performance indicators and water accounting procedures in irrigated agriculture, and to obtain their likely ranges.
M. Tabei; Saeid Boroomand Nasab; A. Soltani Mohamadi; A. H. Nasrollahi
Abstract
Introduction: The to be limited available water amount from one side and to be increased needs of world population from the other side have caused increase of cultivation for products. For this reason, employing new irrigation ways and using new water resources like using the uncommon water (salty water, ...
Read More
Introduction: The to be limited available water amount from one side and to be increased needs of world population from the other side have caused increase of cultivation for products. For this reason, employing new irrigation ways and using new water resources like using the uncommon water (salty water, water drainage) are two main strategies for regulating water shortage conditions. On the other side, accumulation of salts on the soil surface in dry regions having low rainfall and much evaporation, i.e. an avoidable case. As doing experiment for determining moisture distribution form demands needs a lot of time and conducting desert experiments are costly, stimulator models are suitable alternatives in answering the problem concerning moving and saltiness distribution.
Materials and Methods: In this research, simulation of soil saltiness under drip irrigation was done by the SWAP model and potency of the above model was done in comparison with evaluated relevant results. SWAP model was performed based on measured data in a corn field equipped with drip irrigation system in the farming year 1391-92 in the number one research field in the engineering faculty of water science, ShahidChamran university of Ahvaz and hydraulic parameters of soil obtained from RETC . Statistical model in the form of a random full base plan with four attendants for irrigating water saltiness including salinity S1 (Karoon River water with salinity 3 ds/m as a control treatment), S2 (S1 +0/5), S3 (S1 +1) and S4 (S1 +1/5) dS/m, in 3 repetition and in 3 intervals of 10 cm emitter, 20 cm emitters on the stack, at a depth of 0-90 cm (instead of each 30 cm) from soil surface and intervals of 30, 60 and 90 days after modeling cultiviation was done. The cultivation way was done handheld in plots including four rows of 3 m in distance of 75 cm rows and with denseness of 80 bushes in a hectar. Drip irrigation system was of type strip with space of 20 cm pores.
Results and Discussion: The results of this section of work have shown in the form of chart drawing and calculating identity indices or recognition (R2), maximum error (ME), normalized root mean second error (NRMSE) and coefficient of residual mass (CRM) in the distances on the stack, 10 and 20 cm dropper. The amount of R2, ME, NRMSE and CRM in 10 cm dripper were calculated to be 0/81, 0/46, 11/77 and 0/018 mg/cm3, in 20 cmdripper 0/78, 0/48, 16/44 and 0/1172 mg/cm3 and on the stack 0/75, 2/8, 18/19 and 0/07 mg/cm3. The highest recognition factor was a distance of 10 cm dripper (81 percent) and then reduces to keep distance from dripper recognition factor . This subject is the highest potency close to the dripper. This can happen for less saltiness in the spaces close to the dripper according to drip irrigation features. The high ME amount shows the less attendance computing of the model, it comes to it’s maximum on the stack, however (2/8 mg/cm3), the distances near to the dripper the obtained ME amount shows the good care in estimating soil saltiness. Also, based on being positive CRM parameter amount was seen. It is less in the amount observed in anticipating of saltiness in the anticipated amount. By considering NRMSE factor, higher amount of anticipating is based on observations.
Conclusion: Generally, the results obtained from stimulating of SWAP show that this model can stimulate saltiness distribution in soil under drip irrigation with salty water. This model can be used as useful tools for evaluation of saltiness distribution around the dripper.
M. Aghajani; Maryam Navabian
Abstract
Water for rice cultivation is one of the main inputs. The new administration of irrigated rice is increase water efficiency and water conservation in the paddy fields. In this research, for optimization of intermittent irrigation management in proportion to water requirement of different stages of rice ...
Read More
Water for rice cultivation is one of the main inputs. The new administration of irrigated rice is increase water efficiency and water conservation in the paddy fields. In this research, for optimization of intermittent irrigation management in proportion to water requirement of different stages of rice growth was present an optimization- simulation model to maximize irrigation water, transpiration and evapotranspiration productivity Indexes. Irrigation water depth in stages of tiller, vegetative, maturity, harvest and irrigation intervals were selected as decided values in optimization model. Simulation of plant growth stages, using the hydrological model SWAP and genetic algorithm was used to solve the optimization model to maximize agricultural productivity. Finally, the optimum amount of irrigation water productivity, transpiration and evaporation - transpiration were obtained 1.60, 2.90 and 1.33(kg/m3) respectively. Results showed, irrigation water productivity index has more harmonize with Sefidroud irrigation network. Also the index is user-friendly in applying and calculating. So according to maximizing of water productivity index irrigation depth was recommended 51, 29, 39 and 11 mm respectively in stages of tiller, vegetative, maturity, harvest and and 8 days period of irrigation intervals to improve water productivity index in Hashemi variety in Rasht. Optimization results showed optimal intermittent irrigation is successive compared with flood irrigation in rice.
