دوماه نامه

نوع مقاله : مقالات پژوهشی

نویسندگان

1 دانشگاه شهید چمران اهواز

2 اهواز

3 دانشگاه شهید چمران، اهواز

چکیده

به دلیل وجود جریان‌های ثانویه در انحناء رودخانه، دیواره خارجی در پیچ همواره در معرض تخریب و فرسایش می‌باشد. روش‌های متعددی جهت مقابله با فرسایش قوس خارجی وجود دارد که یکی از ساده‌ترین و در عین حال اقتصادی‌ترین این روش‌ها استفاده از آبشکن می‌باشد. آبشکن به عنوان مانعی در مسیر جریان با کاهش سرعت و ایجاد گردابه‌های افقی در بین آبشکن‌ها باعث رسوبگذاری و حفاظت دیواره آبراهه می‌گردد. از طرفی این گردابه‌ها باعث افزایش تنش برشی شده و افزایش فرسایش و آبشستگی را در اطراف آبشکن به خصوص در دماغه به همراه خواهد داشت. در این تحقیق به بررسی هندسه چاله آبشستگی پیرامون آبشکن‌های نفوذپذیر، نفوذناپذیر و باندال‌لایک که به صورت ترکیبی از آبشکن نفوذپذیر و نفوذناپذیر می‌باشد، در قوس 90 درجه ملایم و در شرایط غیر مستغرق پرداخته شده است. برای این منظور در یک فلوم قوسی 90 درجه و ملایم (نسبت شعاع قوس به عرض کانال برابر 4) و دارای بستر رسوبی با قطر متوسط 5/1 میلی‌متر و در شرایط آب زلال، آزمایش‌ها طراحی و انجام شد. بازه تغییرات عدد فرود در آزمایش‌های انجام شده بین 22/0 تا 29/0 متغیر می‌باشد. نتایج بیانگر این بود که با افزایش درصد نفوذپذیری میزان حداکثر ابعاد چاله آبشستگی کاهش می‌یابد. ضمنا افزایش عدد فرود جریان باعث افزایش ابعاد چاله آبشستگی شده که این تاثیر در آبشکن های نفوذپذیر و باندال لایک کمتر بوده است.

کلیدواژه‌ها

عنوان مقاله [English]

Experimental Investigation on the Scour Hole Geometric Dimensions in Different Spur Dikes in 90 Degree Bend for Non-Submerged Conditions

نویسندگان [English]

  • somayeh rahimi 1
  • mahmood kashefipoor 2
  • mahmoud shafai bajestan 1
  • ahmad fathi 3

1 University of Shahid Chamran Ahwaz

2

3 University of Shahid Chamran Ahwaz

چکیده [English]

Introduction: Outer bank region is always exposed to destruction and scour due to secondary flow. Different methods are generally used to protect the outer bank. One of the most common and economical ways is spur dike. As an obstacle in the flow, spur dikes protect the outer bank through decreasing the velocity and forming vortexes between them and as a result sedimentation along that area. However, the spur dike increases the shear stress and local scour around the spur, especially its nose.. This study investigates the scour hole dimensions around three types of spur dike including permeable, impermeable and bandal-like spur dike which is done as a combination of permeable and impermeable spur dike. Few studies were focused on field applications and laboratory experiments to investigate the practical applicability of the bandal-like structure in natural rivers. Rahman et al. (4) Studied the prediction of main channel degradation and local scour around hydraulic structures (impermeable and bandal-like spur dikes) under non-submerged condition. Teraguchi et al. (9) Investigated the influenced of submerged condition on flow characteristics and sediment transport process caused by bandal-like structures with different spacing and alignment under live-bed scour condition through laboratory experiments.
Materials and Methods: Experiments were carried out in the Physical Modeling Laboratory of Faculty of Water Science Engineering of Shahid Chamran University, Ahwaz. The main channel consisted of a 5m long upstream and a 3m long downstream straight reaches. A 90 degree bend was located between the two straight reach. The channel was of rectangular cross section, having a width of 0.7m and depth of 0.6m, with mild bends (ratio of radius to a width equal to 4) and it was filled with almost uniform sediment with a median particle size of D50=1.5 mm. The discharges were measured using an ultrasonic flow meter, which was installed on the pipe inlet of the flume. The water elevation was regulated using the sliding gate installed at the end of the flume. Plexiglas with a thickness of 0.01m was used for impermeable part of spurs and the permeable part prepared by using steel roll piles with 4mm diameter. The most erodible area along the bend was determined and after installing the spurs, the bed surface was leveled by a plate attached to the carriage mounted on the channel. Then the inlet valve was opened slowly and the gate at the end of the flume was first closed. The discharge increased to a predetermined value so that no scour occurs at the straight reaches of the flume. Each experimental case was carried out for 3 hours under clear-water scour condition. At the end of experiments, water was carefully drained out and measurement of bed topography was done using laser bed profiles.
Results and Discussion: The most erodible area along the bend was determined using the procedure described by the U.S. Army Corps of Engineers and in each experimental case specified the critical spur in terms of the maximum erosion around it that happened at the exit of the bend (sections of 80 to 90 degree of bend) and downstream straight reach in all conditions. The centrifugal force will occur has increased the water depth at the exit of the bend. This increase in flow depth is associated with longitudinal negative pressure gradient due to this maximum velocity occurs at the exit of the bend and by this high velocity flow the shear stress increases. The characteristics of the scour hole have been shown to be affected by Froude number and this parameter has a direct relation to maximum relative scour depth and dimensions of the scour hole. The results showed that by increasing the permeability percentage, the amount of maximum relative scour hole depth, length and width decreased. The amount of relative scour depth in permeable and bandal-like spur dike decreased (62% and 55%), and (87% and 76%) for permeability of 33% and 64%, respectively in comparison with impermeable spur dike.
Conclusions: The effect of hydraulic structures, with emphasis in the bandal-like structures, on the scour hole geometric dimensions were investigated in this study. Five types of structures (impermeable, permeable and bandal-like with a permeability of 33% and 64%) were tested experimentally. It was found that:
The increase of permeability, reduced scour rate significantly, such that, the maximum amount of depth, width and length of scour-hole was related to impermeable spur dike (with permeability of 0.0%) and the minimum amount belonged to the permeable spur dike with 64% permeability. The performance of bandal-like structures considering the erosion process around the structures show close results compared with permeable spur dikes.

کلیدواژه‌ها [English]

  • Bandale Like
  • Channel bend
  • River bank protection
1- Fazli M., Ghodsian M., Salehi Neyshabouri S.A.A. 2009. Bed Topography Variations in 90 Degree Bend Due to Diffirent Hydraulic Conditions. Modares Civil Engineering Journal, 35: 123-144. (in Persian)
2- Rahman M.M., Nakagawa H., Ishigaki T., and Khaleduzzaman A.T.M. 2003. Channel Stabilization Using Bandalling. Annual of Diaster Prevention Research Institute, Kyoto University, 46(B): 613-618
3- Rahman M.M., Nakagawa H., Khaleduzzaman A.T.M., and Ishigaki T. 2003. Flow and scour-deposition around bandals. p.177-180. In Proceedings of 5th International summer Symposium,JSCE, Tokyo, Japan.
4- Rahman M.M., Nakagawa H., Khaleduzzaman A.T.M., Ishigaki T., and Muto Y. 2004. On the formation of Stable River Course. Annual of Disaster Prevention Research Institute, Kyoto University, 47(B): 601-616.
5- Rahman M.M., Nakagawa H., Khaleduzzaman A.T.M., and Ishigaki T. 2005. Formation of navigational channel using bandal-like structures. Annual Journal of Hydraulic Engineering, Japan Society of Civil Engineers, 49: 997-1002.
6- Shaker E., Kashefipour S.M. 2014. Experimental Investigation on Velocity and Shear Stress Distributions in a 90-Degree Bend With and Without Series of Groynes. Water and Soil Science, Tabriz University, 24(3): 55-68. (in Persian with English abstract)
7- Sharmin R., Rahman M.M., Matin A., Haque E., Hossain I., and Razzak A. 2007. Effectiveness of Bandalling and dredging for the maintenance of navigation channel in the Jamuna River. p. 125-133. In Proceeding of the International Conference on Water & Flood Management, 12-14 Mar, Dhaka, Bangladesh.
8- Shojaeian Z., Kashefipour S.M., Mosavi Jahromi S.H. 2015. Experimental Study of the Effect of Permeability Percentage of Bandal Like Spur Dike on Maximum Depth of Scour Hole. Water and Soil Science, Tabriz University, 25(3): 105-116. (in Persian with English abstract)
9- Teraguchi H., Nakagawa H., Kawaike K., Bans Y, and Zhang H. 2011. Effects of hydraulic structures on river morphological processes. International Journal of Sediment Research. 26(3): 283-303.
10- Teraguchi H., Nakagawa H., Kawaike K., Baba Y. and Zhang H. 2011. Alternative method for river training works: Bandal-like structures. Annual Journal of Hydraulic Engineering, JSCE, 55: 151-156.
11- United States Army Corps of Engineers, (1981), Roughans Point Revere, Massachusetts Coastal Flood Protection Study. United States Army Corps of Engineers Water Resources Investigation.
12- Zhang H., Nakagawa H., Baba Y., Kawaike K., and Teraguchi H. 2010. Three-dimensional flow around Bandal-like structures. Annual Journal of Hydraulic Engineering, Japan Society of Civil Engineers, 54: 175–180.
13- Zhang H., Nakagawa H., Baba Y., Kawaike K., and Rahman M.M. 2011. Hydraulic and Morphological Consequences of Bank protection measures along the Jamuna river, Bangladesh. Annual of Diaster Prevention Research Institute, Kyoto University, 54(B): 477-496
CAPTCHA Image