Impact of Waste Materials Resulting from the Refining of Crude Oil on Some Soil Physico-Chemical Properties

Document Type : Research Article

Authors

• pari asadi alasvand
• Ahmad Heidari

University of Tehran

https://doi.org/10.22067/jsw.v30i3.40716

Abstract

Introduction: Soil and ground water pollution with organic matter and toxic materials is an ordinary environmental problem. In this case, oil compounds are among the most important environmental pollutants. Tehran oil refinery is one of the largest and oldest refineries in Iran located south of Tehran city. Since the beginning of its activity in 1968, its waste materials (solid, semisolid and liquid) have been disposed in large lagoons next to the refinery site. During this long period, considerable changes in soil properties have occurred, which are of great research interests for soil and environmental scientists.
Materials and Methods: The studied area (about 60 ha) was located in the south of Tehran (latitude: 35°30.299' to 35°30.814' N and longitude: 51°25.682' to 51°26.296' E). Six pedons, including four Technosols developed on the oil refinery waste materials (pedons no. 1, 3, 4 and 6) and two reference pedons (pedons no. 2 and 5) were fully described and sampled. Particle size distribution (PSD) of gypsiferous samples was determined by the specific method for gypsiferous soils (Hesse, 1976). PSD of non-gypsiferous samples were determined according to the standard hydrometer method (Gee and Bauder, 1986), but the oil-polluted samples were analyzed according to the standard ultrasound method (Sawhny, 1996). Organic carbon content was determined by Walkley and Black (1934). pH and EC were measured in soil saturation extracts using EC and pH meter (Jenway). Gypsum and CaCO3 contents were determined using acetone (Sparks, 1996), and calcimetery methods, respectively. Mineralogical analysis was done by Decarreau (1990). Micromorphological descriptions were carried out using the terminology of Stoops (2003). Diagnostic horizons were identified and finally the studied pedons were classified according to the Keys to Soil Taxonomy (Soil Survey Staff, 2014) and the World Reference Base (FAO, 2014).
Results and Discussion: Horizons of both polluted and unpolluted soils were mostly gypseous and/or calcareous especially in the middle parts. Considering the surface and subsurface diagnostic horizons and the aridic-thermic soil moisture and temperature regimes, the studied soils were classified as Gypsids, Calcids or Cambids (Soil Survey Staff, 2014). However, due to the added oil waste compounds and presence of impermeable geomembrane in some of the polluted pedons, they were classified as Technosols in the WRB system (FAO, 2014). Noticeable effects of Pollutants in the soil were decreasing pH and increasing OM and EC. The surface horizons of the unpolluted soils contained less than 2 percent organic matter which regularly decreased by depth. However, In some horizons of the polluted soils, soil organic matter exceeded 12 percent. pH decreased by increasing organic matter (oil waste compounds) possibly due to H+ dissociation from the oil compounds (Laurent et al., 2012). Electrical conductivity throughout the polluted soil horizons showed more limited variability than the unpolluted ones, probably due to their higher capability in water and liquid dynamics. Liquid limit and plasticity limit in polluted soils are higher than unpolluted soils . Plasticity index in polluted soils decreased with increasing the amount of pollutants. The results of mineralogical studies corroborated that dominant clay mineral in this soils is Smectite. Smectites have high swelling and shrinking capacity.So, the pollutants can intercalate between soil mineral layers and then increase d-spacing of clay minerals. The micromorphology of the polluted soils showed that low dielectric constant of petroleum caused flocculation and formation granular aggregates in soil. Studied soils are inactive in terms of activity of clay.
Conclusion: As observed in the studied soils, their physico-chemical properties such as pH and electrical conductivity (EC) of saturated paste extract, organic matter content, mineralogical and micro-morphological properties were severely affected by the oil wastes. These results show these soils have been limited and in use of these soils, considering these properties is required. In polluted soils, due to small differences between plasticity limit and liquid limit, it is possible to their sliding faster than unpolluted soils and then construction should be avoided.

Keywords

• Oil waste
• Polluted soil
• Physico-Chemical properties

20.1001.1.20084757.1395.30.3.17.1

References

1- Abdallah I., Ahmed S., and Osama T .1999. Effects of organic matter on the physical and the physicochemical properties of an illitic soil. Applied Clay Science, 14: 257–278.

2- Ahmadi A,. Talaie E., and Soukoti R. 2012. Pedotransfer functions for estimating atterberg limits in semi-arid areas. International Journal of Agriculture: Research and Review. Vol., 2 (4): 491-495.

3- Alsanad H.A., Eid w.k., and Ismael N.F. 1995. “Geotechnical properties of oil contaminated Kuwaiti sand,” Journal of Geotechnical Engineering, ASCE, 121 (5), 407–412.

4- Bower C.A., ReiteMeier P.F., and Fireman, M. 1952. Exchangeable cation analysis of saline and alkali soils. Soil Sci, Vol., 73: 251–261.

5- Cathy A., Seybold M., Elrashidi A., Robert J., and Engel M. 2008. Linear regression models to estimate soil liquid limitand plasticity index from basic soil properties. Vol. 173, No. I, 0038-075X/08/17301-25-34.

6- Das B.M. 2002. Principles of Geotechnical Engineering, Fifth Edition. Thomson Learning Academic Resource Center, USA, pp. 26–28.

7- Decarreau A. 1990. Les poudres : techniques experimentales et interpretation des diagrammes – Facteurs determinant le mode d’empilement. In Structure, proprietes et applications. Societe Française de Mineralogie et cristallographie, Groupe Français des Argiles, 209–236.

8- Gee G.W., and Bauder J.W. 1986. Particle-size analysis. In: Klute, A. (Ed.) Methods of Soil Analysis. Part 1Physical and Mineralogical Methods American Society of Agronomy, 383–411.

9- Gitipour S., Nabi G.h., and Gorji M.A. 2004. Soils contaminated by leaking petroleum compounds in south of Tehran Refinery. Jornal of ecology. vol 34: 39-45.

10- Grossman R.B., and Reinsch T.G. 2002. Bulk Density In: Carter E.G. Soil Sampling and Methods of Analysis Second Edition, Edited by M.R. Gregorich.

11- Hesse P.R. 1976. Particle size distribution in gypsic soils. Plant and Soil, Vol., 44: 241-247.

12- Kaya A., and Fang H.Y. 2000. The effects of organic fluids on physicochemical parameters of fine-grained soils. Canadian Geotechnical Journal 37: 943–950.

13- Khamehchiyan M., Charkhabi A. H., and Tajik M. 2007. “Effects of crude oil contamination on geotechnical properties of clayey and sandy soils Method,” Engineering Geology Vol., 89: 220–229.

14- Laurent F., Cebron A., Schwartz C and Leyval C. 2012. Oxidation of a PAH polluted soil using modified Fenton reaction in unsaturated condition affects biological and physico-chemical properties Chemosphere. 86: 659–664.

15- McBride R.A. 2002. Univercity of Guelph, Guelph, Ontario, Canada. Atterberg limits, In: Jacob H. Dane and G.Clarke Topp, Co-editors. Methods of Soil Analysis, Part 4, Physical Methods, Vol 1. Soil Science Society of America, Inc. Madison, Wisconsin, USA.

16- Meegoda N.J., and Ratnaweera P. 1994. Compressibility of contaminated fine grained soils. Geotechnical Testing Journal 17 (1): 101–112.

17- Minai-Tehrani D., Herfatmanesh A., Azari-Dehkordi F., and Minooi S. 2006. Effect of salinity on biodegradation of aliphatic fractions of crude oil in soil. Pak.J.Biol.Sci 9: 1531-1535..

18- Mitchell J.K., and Soga K. 2005. Fundamental of Soil Behavior, 3rd ed., Wiley, New York,.

19- Olgun M. 2008. The investigation of shear strength and consolidation behaviors of clay soils consolidated with chemicals of various concentrations. Ph.D. thesis, Selcuk University, Konya.

20- Pansu M., Jacques G. 2006. Handbook of Soil Analysis Mineralogical, Organic and Inorganic Methods,.

21- Pansu M., Gautheyrou J., and Loyer J.Y. 2001. Soil Analysis – Sampling, Instrumentation and Quality Control, Balkema publishers, Lisse,Abington, Exton, Tokyo, 512 p.

22- Ratnaweera P., and Meegoda J.N. 2006. Shear strength and stress–strain behaviour of contaminated soils. ASTM Geotechnical Testing Journal 29 (2): 133–140.

23- Rahman Z., Hamzah U., and Taha M. 2010. Influence of Oil Contamination on Geotechnical Properties of Basaltic Residual Soil. American Journal of Applied Sciences 7 (7): 954-961.

24- Shah S.J., Shroff A.V., Patel J.V., Tiwari K.C., and Ramakrishnan D. 2003. Stabilization of fuel oil contamination soil-a case study. Geotech. Geol. Eng., 21: 415-427.

25- Sivapulliah P.V. 1987. Effect of polluted water on the physico-chemical properties of clayey soils. In: Environmental Geotechnica, Balkema Press, Rotterdam.

26- Smith C.W., Hadas A., Dan J., and Koyumdjisky H. 1985. Shrinkage and Atterberg limits in relation to other properties of principal soil types in Israel. Geoderma Vol. 35: 47-65.

27- Sparks D. L. 1996. Method of soil Analysis. Part 3. Chemical Methods. American Society of Agronomy.

28- Sridharan A., El-Shafei A., and Miura N. 2000. A study on the dominating mechanisms and parameters influencing the physical properties of Ariake clay. International Association of Lowland Technology Journal 2: 55–70.

29- Stoops G. 2003. Guidelines for the Analysis and Description of Soil and Regolith Thin Sections. SSSA, Madison, WI.

30- Tuncan M., Tuncan A., and Koyunau H. 1996. Pilot field study of petroleum contaminated waste stabilization. Proc. Int. Symp. Environmental Geo technology, (Pennsylvania USA), Vol. 1 pp. 153.

31- United States Department of Agriculture, Natural Resources Conservation Service. 2010. Keys to Soil Taxonomy By Soil Survey Staff. Eleventh Edition.

32- Walkley A., and Black I.A. 1934. An Examination of the Degtjareff Method for Determining Soil Organic Matter, and a Proposed Modification of the Chromic Acid Titration Method. Soil Sci. 34: 29-38.

33- World Reference Base for Soil Resources. 2006. ISBN 92-5-105511-4. A Framework for International Classification, Correlation and Communication, Rome, Italy.