تأثیر چرخه های تر و خشک شدن بر منحنی فشردگی و ارزیابی روش های برآورد

نوع مقاله : مقالات پژوهشی

نویسندگان

چکیده

تر و خشک شدن با ایجاد تنش در خاک، ساختمان فیزیکی آن را تغییر می دهد. به همین منظور، اثر این فرآیند بر ارزیابی روش های برآورد آستانه ی تراکم پذیری (ظرفیت باربری یا تنش پیش-تراکمی) یک خاک درشت بافت (لو م شنی) تهیه شده از مزارع شرکت توسعه نیشکر و صنایع جانبی اهواز، مورد بررسی قرار گرفت. در این پژوهش روش های نشست صفحه ای (PST) و فشردگی محصور ارزیابی شدند. نمونه های بزرگ خاک تهیه و برخی از آن ها تحت تأثیر 5 چرخه تر و خشک شدن قرار گرفت. سپس نمونه های با یا بدون فرآیند تر و خشک شدن تحت سه بار (0، 100 و 200 کیلوپاسکال) متراکم گردید و آزمایش نشست صفحه ای در مرکز نمونه ها انجام شد. از اطراف محل این آزمایش، نمونه ای برای انجام آزمایش فشردگی محصور تهیه گردید. نتایج نشان داد که برای حالت بدون تر و خشک شدن، اختلاف معنی داری بین بار وارد شده به نمونه و مقادیر به دست آمده از آزمایش PST وجود نداشت. در صورتی که برای خاک تر و خشک شده، مقادیر به دست آمده به طور معنی داری بیشتر از بار متراکم-کننده بود. پس می توان برای خاک های خاک ورزی شده به منظور تعیین پارامترهای تراکمی آن از روش PST به عنوان یک روش سریع و قابل اجرا در آزمایشگاه و مزرعه استفاده نمود.

کلیدواژه‌ها


عنوان مقاله [English]

Effect of Wetting and Drying Cycles on Compaction Curve and Evaluation Methods for Estimating Compactibility of a Coarse Textured Soil

نویسندگان [English]

  • M. Salehian Dastjerdi
  • A. Hemmat
چکیده [English]

Wetting and drying induce stresses in soil which changes the physical structure of the soil. For this reason, the effect of this process on evaluating the methods for estimating the threshold of compactibility (load-bearing capacity, pre-compaction stress) of a coarse textured soil (sandy loam) collected from the fields of the Sugarecane and By-product Development Co. in Ahvaz province was studied. In this research, the plate sinkage test (PST) and confined compression test (CCT) methods were evaluated. Large air-dry disturbed soil samples were prepared and some of them were exposed to five wetting and drying cycles. After that, the large soil samples with/without wetting and drying cycles were compressed under three loads (0, 100 or 200 kPa) and then the centre section of the preloaded soil samples was firstly submitted to PST. Then immediately one cylindrical sample was cored for CCT. The results showed that for the soil samples without wetting and drying process, there was no significant difference between the applied load and the estimated values using PST method. However, for the soil samples under wetting and drying process, the obtained values were significantly greater than the applied loads. Therefore, for tilled soil, PST can be used as a quick method to determine the compression parameters of the soil in laboratory or in the field.

کلیدواژه‌ها [English]

  • Flood irrigation
  • Wetting and drying cycles
  • Pre-compaction stress
CAPTCHA Image